Pioneer PDP-502MX Manual page 68

Tiltable Plasma Display Wall-Mount Hardware: PDK-5006
3) Mounting the monitor-fastening bolts to the plasma display
1 Mount the monitor-fastening bolts to the four rear corners of the plasma display.
104
20-M8 (With a
2 Mounting the assembled mounting hardware to the wall.
1. Firmly fasten the mounting hardware to the wall at a minimum of four points (b), using appropriate screws or
bolts. Make sure that the screws and bolts are appropriate for the wall's strength and composition.
CAUTION
Before mounting to the wall, check that the fittings have adequate strength.
68
1162
590 104
590
16 hole rivet)
b
b
Monitor-
fastening bolt
Monitor-
fastening bolt
The nuts of the monitor-
fastening bolts should be
tightened so that their surface
is level with the screw.
b
b
Monitor-
fastening bolt
Monitor-
fastening bolt