Precautions For Mounting Various Metal Fixtures After The Optional Speakers Are Attached To The Plasma Display Main Body - Pioneer PDM-4001 Technical Manual

Mounting standard metal fixtures
(Precautions for installing the optional speaker)
4.12.4 Precautions for mounting various metal fixtures after the optional speakers are attached to
the plasma display main body
When various metal fixtures are to be mounted after the optional speakers have been mounted to the plasma display,
the following steps and precautions must be observed, depending on the specific type.
1) Tilted stand (PDK-4001)
Bolt
(supplied with the PDK-
4001)
Washer of φ 25-mm outer diameter
(supplied with the optional speaker)
When mounting the optional speaker, tighten the PDK-4001 and optional speaker with the mounting screws
supplied with the PDK-4001. However, for the center section with no speaker metal fixture, align the height by
inserting under the speakers the outer diameter φ 25 mm washers supplied with the speaker.
128
Washer
(supplied with the PDK-4001)
Washer
Bolt
(supplied with the
(supplied with the
PDK-4001)
PDK-4001)
Fig. 1