Assembling The Mounting Hardware And Mounting The Plasma Display - Pioneer PDP-501MX Technical Manual

THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION

4.5.2 Assembling the mounting hardware and mounting the plasma display

1) Precautions
• Make sure you distinguish correctly between vertical frames for left and right. Both should be mounted so their
hexagonal sockets face outward.
• The horizontal frames should be mounted so their smaller openings face the wall. A total of eight openings are
provided in the horizontal frames for wall-mounting. (A total of fourteen openings are provided in the PDK-5006 itself.)
2) Assembly procedure
1 Loosen screw a and separate one end of the hook from the screw.
2 Hold the upper part of the vertical frame and open to an approximate width of 10 cm.
3 Mount the horizontal frame to the vertical frames.
Vertical frame (right)
Hexagonal
socket head
flange bolt
Hexagonal
socket head
flange bolt
50 THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
a
Loosen the screw until you can no longer
see its end through this opening.
Vertical frame (left)
Horizontal frame
Hexagonal sockets
facing outward
Horizontal frame
This side should face the wall. (The
smaller holes should face the wall.)
a
Hexagonal socket head
flange bolt
This surface should face the wall.
Hexagonal socket head
flange bolt
Positioning the screw with a finger-tip, tighten
the screw with a hexagonal wrench.
Hexagonal
wrench