Mounting Procedures - Pioneer PDP-502MX Manual

4.8.3 Mounting procedures

For the sake of safety, this operation should be performed
by two or more persons.
1 Attach the panel support to the leg base.
Attach the support post using hexagonal socket
head bolts (M8 70) and leg base collars, as shown,
so that the label in the rear is facing in the direction
of the rear casters.
*Use the binder clips to secure the power cord,
computer connector cable, BNC terminal cable, etc.
(NOTE) In order to ensure that the bolts are safely
tightened, tighten them twice or more,
alternately.
Label
Support caster
Back casters
2 Attach the cord clip to the display stand.
*The cord clip is designed for use in binding together
power cables, computer cables, or BNC terminal
cables.
Display stand
Leg base
Leg base
collar
Washer
Cord clip
3 Mount the bracket support bolts on the support panel.
Mount hexagonal socket head (M8 20) to the panel
support, leaving a 5 to 6 mm gap, as shown.
(There are three mounting levels available, such that
the center of the display's screen is 1350, 1125, or
1100 mm, respectively, from the floor.)
(NOTE) Don't mount to the fourth opening from the
top. It will be used in step 4, if the highest
level mounting is employed.
Panel
support
Plate spring
washer
Hexagonal bored
bolts (M8 x 70)
4 Mount the plasma display on the bracket.
Using hexagonal socket head bolt (M8 20), attach
the bracket to the screw openings in the rear of the
plasma display, as shown.
(NOTE) We advise that you spread a blanket or soft
cloth to prevent scratching of the front of the
plasma display.
Bracket
Carriable Stand: PDK-5008
Hexagonal
socket head bolt
(M8 x 20)
Hexagonal bored
bolt (M8 x 20)
Plasma display
5 to 6
mm
73