Settings In Menu Mode; Setting Power Save - Pioneer PDP-502MX Manual

5.3.3 Settings in menu mode

1) Setting power save

This is a function that automatically switches to a power-saving mode when a picture signal (sync signal) is not
detected.
When input signals consist of PC signals, it is also possible to specify that an automatic reset be performed upon the
re-input of video signals.
Set to OFF when using power save mode. =
Go into power standby mode when no input signal is detected over a period of 8 minutes or more.
Switch between normal operating mode and power save mode depending on the presence or absence of input
signals.
MODE 2 can only be set for PC signal.
Factory preset:
1 Select POWER SAVE.
Screen 1
MAIN MENU
PICTURE
SCREEN
ALL RESET
3POWER SAVE
SET UP
MENU : MENU OFF
5∞ 3
: SELECT
(NOTE) MODE 1: Press the STANDBY/ON button on the remote control unit or the main unit operation panel
MODE 2: Operate the PC connected to the display or press the INPUT button on the remote control
MODE 1: The power consumption in standby mode is 0.6W
MODE 2: The power consumption in power-saving mode is about 160W.
=
=
VIDEO : OFF
PC : OFF
CONTRAST : 0
: 0
BRIGHT
: 0
COLOR
: 0
TINT
: 0
SHARP
RESET
SET : NEXT
in order to change from standby mode to normal operating mode
unit or the main unit operation panel in order to return from power-saving mode to normal
operating mode
Set OFF
Set MODE 1
Set MODE 2
2 Bring the cursor to VIDEO (or PC), change the
setting with the SET button.
When the SET button is pushed:
VIDEO selected:
PC selected:
Screen 2
POWER SAVE
3VIDEO : MODE 1
PC : MODE 2
EXIT
5∞ 3
: SELECT
Menu Mode
OFF Ô MODE
OFF = MODE 1 =
MODE 2 = ...
CONTRAST : 0
: 0
BRIGHT
: 0
COLOR
: 0
TINT
: 0
SHARP
RESET
SET : CHANGE
97