Adjusting Mower Cutting Height; Pushing The Tractor By Hand; Attachinga Trailer - Snapper LT-200 Series Operator's Manual

Adjusting Mower Cutting Height
The cutting height lift lever (A, Figure 9) controls the mower
cutting height. The cutting height is has seven positions
between approximately 1-1/4 in. and 4 in. 3.2-10 cm).
Figure 9: Raising and lowering mower
A - Mower Lift Lever
Pushing the Tractor by Hand
1. Disengagethe PTOand turn the engine off.
2. Pull the transmission release(B, Figure 10) back
approximately 2-3/8 in. (6 cm) to lock into released
position.
3. The tractor can now be pushed by hand.
NOTICE Q
DO NOTTOW TRACTOR
Towingthe unitwill causetransmissiondamage.
• Do not use anothervehicle to pushor pull this unit.
• Do not actuatethe transmissionrelease valve lever
while the engine is running.
\
JJJ, 7/
Figure 10. Transmissionreleaselever and fuel tank
A - Fuel Tank Cap
B - TransmissionRelease Lever
Attachinga Trailer
The maximum horizontal drawbar force allowed is 280
Newton. The maximum vertical drawbar force is 160 Newton.
This equatesto a 250 Ib (113 kg) trailer on a 10 degree hill.
Securethe trailer with an appropriately sized clevis pin (A,
Figure 11) and clip (B).
I
J
®
1411
(lm)
10 °
20' (6m)
Figure 11. Trailerweight recommendations
A - Clevis Pin
B- Clip
19