Snapper LT-200 Series Operator's Manual page 79

Figure 31: PTOclutch adjustment
A - Adjustment Window (Qty. 3, one shown)
B - Adjustment Nut
Figure 32: Adjust PTOclutch
A - Window
B - Adjustment Nut
C - FeelerGauge
Mower Adjustments- GaugeWheels
The mower gauge wheels can be placed in two positions
depending on the height of cut. When using higher cutting
heights, set the wheels in the lower position. When using
lower cutting heights, set the wheels in the upper position.
Do not allow wheels to remain on the ground constantly
while mowing. To adjust:
1. Remove the Iocknut (B, Figure 33), gauge wheel (C),
washers (D), and shoulder bolt (E). Changeposition of
gauge wheel to desired height.
2. Insert shoulder bolt (E) through washers (D) gauge
wheel (C), and gauge wheel bracket (A). Secure with
Iocknut (B). Repeatsteps 1 and 2 for all gauge wheels.
Figure 33: Fixed bracket gauge wheeladjustment
A - Gauge Wheel Bracket
B - Locknut
C - Gauge Wheel
D- Washer
E - Shoulder Bolt
35