Adjusting Mower Cutting Height; Attaching A Trailer; Storage - Snapper ELT18540 Operator's Manual

Adjusting Mower Cutting Height

The cutting height lift lever (A, Figure 4) controls the mower
cutting height. The cutting height is has seven positions
between approximately 1-1/4" and 4" (3,2-10 cm).
Figure 4. Raising & Lowering Mower
A. Mower Lift Lever

Attaching a Trailer

The maximum horizontal drawbar force allowed is
280 Newton. The maximum vertical drawbar force is
160 Newton. This equates to a 250 lbs (113 kg) trailer on
a 10 degree hill. Secure the trailer with an appropriately
sized clevis pin (A, Figure 5) and clip (B).
A
B
Figure 5. Trailer Weight Recommendations
A. Clevis Pin
B. Clip

Storage

Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. Fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety Rules
section, then perform the following steps:
• Disengage the PTO, set the parking brake, & remove
the key.
• Perform engine maintenance and storage measures
listed in the engine owner's manual. This includes
draining the fuel system, or adding stabilizer to the
A
fuel (do not store a fueled unit in an enclosed structure
- see warning).
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a month.
If the battery is left in the unit, disconnect the negative
cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in the engine owner's manual.
• Allow the engine to warm up for several minutes
before use.
15
Operating the Tractor
WARNING