Transmission Maintenance; Hood Removal And Installation - Snapper LT-200 Series Operator's Manual

Transmission Maintenance
TransmissionIdentification
To determine what transmission is in your tractor, check the
identification tag attached to the axle of the transmission
(Figure 14), or check your tractor's parts book.
K46 Maintenance
The K46 is a sealed unit and does not require regular
maintenance. If the transmission lacks drive or is excessively
noisy, it may need to be purged. See your Dealer.
Figure 15. Headlight
A - Socket and Bulb
B - Bezel
Figure 14: TransmissionID tag location
A - ID Tag
Hood Removal and Installation
Hood Removal
1. Open the hood.
2. Removethe socket and bulbs (A, Figure 15) by twisting
the socket counterclockwise and pulling it out of the
bezel (B). Repeaton other side.
3. Rock the hood back slightly and lift hood (B, Figure 16)
off pivot posts (C). Set hood on a clean and flat
surface.
Hood Installation
1. Set hinge posts (A, Figure 16) onto pivot posts (C).
2. Roll the hood forward until it reachesthe stops (D).
3. Install the socket and bulb (A) by pushing it into the
bezel (B) twisting the socket and bulb clockwise.
Repeaton other side.
4. Close the hood.
Figure 16. Hood removal and installation
A - Hinge Post
B - Hood
C - Pivot Post
D - Stop
23