Snapper LT-200 Series Operator's Manual page 57

PTOSwitch- The PTO(Power Take-Off) switch
engages and disengages attachments that use the PTO.To
engage the PTO,pull UP on the switch. Push DOWNto
disengage. Note that the operator must be seated firmly in
the tractor seat for the PTOto function.
1_) Ignition Switch-- The ignition switch starts and
stops the engine, it has three positions:
©
0
OFF
RUN
START
Stops the engine and shuts off the electrical
system.
Allows the engine to run and powers the
electrical system.
Cranksthe engine for starting.
NOTICE
Never leave the ignition switchin the RUN position
with the engine stopped- this drains the battery.
4_
;I;
* GroundSpeed Pedals-- The tractor's forward
ground speed is controlled by the forward ground speed
control pedal. The tractor's reverse ground speed is
controlled by the reverse ground speed control pedal.
Depressing either pedal will increase ground speed. Note
that the further down the pedal is depressed,the faster the
tractor will travel.
;_ Cruise Control-- The cruise control is used to
lock the ground speed control in forward. The cruise control
has five lock positions.
_e,4 Mower Height of Cut Adjustment-- The mower
cutting height adjustment lever controls the mower cutting
height. The mower cutting height can be set to one of seven
positions between 1-1/4 and 4 in.
J-- Seat AdjustmentLever -- The seat can be adjusted
forward and back. Move the lever, position the seat as
desired, and releasethe lever to lock the seat into position.
TransmissionRelease Valve Lever -- The
transmission releasevalve lever deactivatesthe transmission
so that the tractor can be pushed by hand. See Pushing the
Tractor by Hand in the Operationsection for operational
information.
Pa
•-'_ Fuel Tank -- To remove the cap, turn
counterclockwise.
12V
Power Outlet(Select Models) -- The power outlet is
12V-DC.Accessory must be rated at 9 amps or less.
'' Fuel Level Gauge -- Displays the fuel level in the
tank.
Parking Brake --The parking brake knob is used to
lock the parking brake when the tractor is stopped. Fully
depressing the brake pedal and pulling up on the knob
engagesthe parking brake. Refer to Parking Brake Function
below for a full explanation.
(0)
Brake Pedal- Depressing the brake pedal applies
the tractor brake.
13