Assembly - NordicTrack Smart Terrain 12.0 NTEL01310.3 User Manual

ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
in addition to the included tool(s), assembly requires a Phillips screwdriver _L_===_, an adjustable
wrench __, and a rubber mallet _.
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M8 Locknut
(102)-4
M8 Star
Washer (122)-4
Wave Washer
(95)-4
1
M8 x 25mm
Washer (98)-6
#8 x 1/2"
Screw (124)-4
#8 x 3/4"
Screw (123)-11
M8 x 35mm
Bolt (96)-4
M6 x 10mm Patch
Screw (121)-8
M8 x 16mm Patch
Screw (120)-6
M8 x 19mm Patch
Screw (82)-4
M10 x 75mm Patch
Screw (119)-2
M10 x 90mm Patch
Screw (84)-2
5