Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 5.
1. Go to www.iconsupport.eu on your computer
and register your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Service
• allows us to notify you of upgrades and offers
Note: If you do not have internet access, call
Customer Service (see the front cover of this
manual) and register your product.
2. With the help of a second person, raise the
Upright (2) to the vertical position.
While a second person holds the Upright (2),
attach the Upper Pillar (47) to the Lower Pillar
(48) with two M8 x 45mm Bolts (124) and two
M8 Locknuts (123); start both Bolts, and then
tighten them. Make sure that the indicated
Locknut is in the hexagonal hole (A).
• In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
two adjustable wrenches
one rubber mallet
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
2
124
6
2
47
A
123
124
123
48
Advertisement
Table of Contents
