NordicTrack Smart Terrain 12.0 NTEL01310.3 User Manual page 11

13. Apply grease to a Pedal Arm Axle (36) and to a
Wave Washer (95).
Orient an Upper Body Leg (46) as shown.
Note: For clarity, the Right Upper Body Arm (61)
is not shown in this step.
Insert the Pedal Arm Axle (36) through the Right
Pedal Arm (58), the Wave Washer (95), and the
Upper Body Leg (46).
Next, insert a hex key into the M8 x 16mm
Patch Screw (120) in the Pedal Arm Axle (36).
Using a second hex key, tighten another M8 x
16mm Patch Screw (120), an Axle Cover (53),
and an M8 x 25mm Washer (98) into the other
end of the Pedal Arm Axle (36).
Repeat this step on the other side of the
elliptical.
13
58
G tease
36
120
14. Insert the Right Upper Body Arm (61)into the
right Upper Body Leg (46).
Attach the Right Upper Body Arm (61) with two
M8 x 35mm Bolts (96) and two M8 Locknuts
(102). Make sure that the Locknuts are in the
hexagonal holes.
Repeat this step for the Left Upper Body
Arm (47) and the other Upper Body Leg (46).
14
47
96
Hexagonal
Holes
46
102
11