NordicTrack Smart Terrain 12.0 NTEL01310.3 User Manual page 9

9. 9
Using a small plastic bag to keep your fingers
clean, apply some of the included grease to the
Pivot Axle (35) and to two Wave Washers (95).
Insert the Pivot Axle (35) through the Upright (4)
and then center it. Tip: It may be helpful to
use a rubber mallet.
Identify the Right Upper Body Arm (61), which is
marked with a "Right" sticker, and orient it as
shown.
Tip: Avoid pinching the Right Control Wire
(41). Slide a Wave Washer (95) and the Right
Upper Body Arm (61) onto the right side of the
Pivot Axle (35).
Insert the Right Control Wire (41) through the
Right Inner Cover (68) as shown.
Repeat this step for the Left Upper Body
Arm (not shown).
4
Avoid pinching
the wires
68
61
95
41
10. Tip: Avoid pinching the wires. Tighten an M8
x 16mm Patch Screw (120) and an M8 x 25mm
Washer (98) into each end of the Pivot Axle (35)
at the same time.
10
Avoid pinching
the wires
35
98
120
9