Replacing Light Bulbs; Troubleshooting; Replacement Parts List - Montigo P42DF Prestige Series Installation & Maintenance Manual

P42DF* Indoor Gas Fireplace

Replacing Light Bulbs

The P42DF* light bulbs can be replaced in a few simple steps. Follow
the directions for removing the door on page 20. Once the door has
successfully been removed, proceed with figures 26 - 26b.
Figure 26. Remove the up-lighting glass from the burner tray.
Figure 26a. Wear gloves when handling light bulbs. To remove
a light bulb, pull connecting wire away from bulb and pull
light bulb up. Replace with new light bulb.
Figure 26b. Rotate newly replaced bulbs in a full circle. Place
glass cover back in the burner tray.
All spare parts, optional fans, and optional trim finishes are available from your local Montigo dealer.
Page 24
Maintenance
If your fireplace still does not operate correctly, consult your local Montigo dealer.
All service and repairs should be performed by a qualified Technician.

Troubleshooting:

SIT Proflame:
The following is a troubleshooting chart of possible problems:
PROBLEM
Pilot won't ignite or spark.
Main burner will not light.
One or more light bulbs are
not working
Fan not working

Replacement Parts List

NG Gas Valve with Stepper Motor
LP Gas Valve with Stepper Motor
NG Pilot Assembly
LP Pilot Assembly
Igniter Probe Assembly
Flame Sensor Rod Assembly
Burner
NG Burner Orfice
LP Burner Orfice
Pilot Tubing - 18"
Control Module
Wiring Harness
DC Adapter
Door Assembly
SOLUTION
- Check the on the batteries on the
remote or the receiver.
- Check the green LED on AC adaptor
-Check the green ground wire under
the valve
- Check the wiring on the valve as per
diagram
- Contact the local dealer for repairs
or service
- Make sure the fan speed control is on.
- 10 minute delay to turn on.
P42DF*
RGC3033
RGC3034
RPA033
RPA034
RGC3052
RGC3053
Contact Dealer
R0R1150
R0R1157
RPTA03
RGC3035
RGC3041
RGC3043
RDTP52
XG0195 - 030712.1