Replacing Light Bulbs - Montigo RP620 Installation & Maintenance Manual

Replacing Light Bulbs

The RP620* light bulbs can be replaced in a few simple steps. Begin
by disconnecting the power to the fireplace. Follow the directions for
removing the screen and outer glass on page 30. Once the screen
and outer glass have been successfully removed, proceed with
figures 28 - 28b.
Note: Always wear gloves when handling the fireplace light bulbs
or glass panels.
Step 1: Remove remove any decorative media and up-lighting
glass from the light kit tray.
Figure 28.
Step 2: To remove a light bulb, pull the light bulb away from the
light bulb connector and lift the light bulb up and out.
Figure 28a. .
Step 3: Rotate the newly replaced light bulb in a full circle.
Figure 28b.
Step 4: Replace up-lighting glass in the burner tray.
XG0777 - 100113.1
Maintenance
RP620 Power Vent Indoor Gas Fireplace
Page 39