Optional Equipment; Lp Conversion Kit; Lp Conversion Instructions - FireplaceXtrordinair 36 DV EFIII Owner's Manual

Optional Equipment

LP Conversion Instructions

Install the conversion kit prior to installing the gas line to ensure proper gas use.
1 Remove the glass (see page 27). Remove the logs and coals (if installed - page 28)
2 Remove the burner (see illustration below).
a
Remove the firebox floor.
WARNING:
The burner is fragile -
c
handle it with care.
Lift the left side of the
burner slightly, then slide it
to the left and lift it upwards
(lift the burner from below).
Pull the burner forward, out
of the firebox.
Burner Replacement:
Make sure the burner is fully seated.
When in place, the pilot flame must align
directly above the burner holes.
Make sure the mixing tubes
slide onto the orifices.
Mixing Tubes
Travis Industries
d
Make sure the bolt head on
the bottom of the burner
inserts into this hole.
4040708
(for qualified installers only)
Lift the pilot hood off the pilot
b
assembly (you may need to
pull hard to remove).
Replace the pilot hood
after replacing the burner.
Slide the air shutters all the
way to the right before
installing the burner.
Orifices
4 3
NOTE:
Make sure the burner is
fully seated. When in
place, the pilot flame
must align directly above
the burner holes.
1 0 0 - 0 1 1 6 0