Optional Equipment
4 8
Attach the starter ring to the fireplace following the directions below (use the most
convenient side).
Install the air duct. Each section, when joined, must be attached with three screws and duct tape (U.L.
181A-P or equivalent). Secure the duct if it is in an area where it may sag or become dislodged.
NOTE:
Travis Industries
The air duct has a 0" clearance to combustibles.
(for qualified installers only)
1/4" Nutdriver
Starter Ring
Remove and discard the
cover plate.
Bend the tabs on the bottom of
the starter ring up to lock it in
place.
4040708
Secure all ducting
together with screws.
Then seal the seams
with aluminum duct
tape (U.L. 181A-P or
equivalent).
1 0 0 - 0 1 1 6 0