Finalizing The Installation; Glass Frame Removal (& Installation) - FireplaceXtrordinair 36 DV EFIII Owner's Manual

Finalizing the Installation

1 Remove the glass frame (and arch covers) following the directions below.
Warning: The appliance must be completely cool before removing the glass.
Note: If using an arch face, attach the arch covers after re-installing the glass.
Open the four latches holding the glass
a
frame in place (start with the bottom
two) - follow the directions shown to the
right.
Glass Frame
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions to the right in reverse).
c) Lift the glass frame slightly and attach the lower latches.
Arch Covers (both sides)
Glass
Frame
Arch Cover
Glass
Travis Industries
NOTE:
You may need to lift
the glass frame
while re-attaching.
The arch covers (included
in the owner's pack) block
light from exiting the scroll
work on arched faces.
The covers hang on the
glass frame.
Arch Faces:
Attach arch covers before
installing the face.
Rectangular Faces:
Discard the arch covers.
4040708
Spring Pin
Top of
Firebox
Glass
Latch Bracket
2 7
Insert the 1/4" key
into the spring
pin.
Twist 1/4 turn.
The spring pin will
disengage from the
latch bracket,
opening the latch.
1 0 0 - 0 1 1 6 0