Installation; Preparations - Husqvarna Automower 210 C Operator's Manual

Hide thumbs Also See for Automower 210 C:
Table of Contents

Advertisement

3. Installation

This chapter describes how you install Husqvarna
Automower
®
. Before starting the installation read the
previous chapter 2. Presentation.
Read the whole of this chapter too before starting the
installation. How the installation is made also affects how
Automower
®
well
will work. It is therefore important to plan
the installation carefully.
Planning is simplified if you make a sketch of the working
area, including all obstacles. This makes it easier to see how
the boundary wire should ideally be placed. Draw how the
boundary wire is to be routed on the sketch.
Carry out the installation in the following steps:

3.1 Preparations.

3.2 Installation of the loop generator/charger
3.3 Charging the battery.
3.4 Installation of the boundary wire.
3.5 Connecting the boundary wire.
3.6 Checking the installation.
3.7 Linking Automower® to the loop generator/charger
In order to carry out a complete start-up of
loop generator/charger and boundary wire must be
connected and the mower linked to the loop
generator/charger. If you would like to start the mower
without having completed the full boundary installation, you
can connect a temporary short loop around the mower.
3.1 Preparations
1.
If the lawn in the proposed working area is taller than
10 cm, mow it using a normal lawn mower. Then collect
the clippings.
2.
Read carefully through all the steps before the
installation.
3.
Check that all parts for the installation are included:
The numbers in brackets refer to the detail diagram
2.1 Automower
®
, what's what? on page 11.
• Operator's Manual (23)
®
• Automower
• Loop generator/charger (18)
• Loop wire for the boundary wire (15)
• Staples (19)
• Connector for the loop wire (20)
• Measurement gauge (21)
• Solderless coupler for the loop wire (22)
During installation you will also need: A hammer to knock the
staples into the ground, combination pliers, and a straight
spade if the boundary wire is to be buried.
3. INSTALLATION
Automower
®
the
English - 15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents