Changing The Pin Code; Charging And Storage Between Mowing - Husqvarna Automower 210 C Operator's Manual

4.7 Changing the PIN code

To change the PIN code on the mower:
1. Connect the loop generator/charger charging
cable to the mower's charger contact. At most
the mower may be two metres from the working
area's boundary wire and the loop
generator/charger must be connected to the
mains supply.
2. Open the control panel cover by pressing the
STOP button. Set the main switch to the ON
position.
3. State the current PIN code, confirm by pressing
the YES button.
4. The yellow indicator lamp PIN code should now
be lit with a steady light.
5. Press and hold the number 8 key on the control
panel for 2 seconds.
6. The yellow indicator lamp PIN code should now
flash.
7. Select and enter a new four digit PIN code. All
combinations except 0000 are permitted.
8. Press the YES button.
9. Confirm the selected PIN code by re-entering the
PIN code.
10. Press the YES button.
11. The yellow indicator lamp PIN code should now
be lit with a steady light.
4.8 Charging and storage between
mowing
When the Automower
lawn, and the green indicator lamp starts flashing. To
charge the mower:
1. Set the main switch to the ON position and leave
the cover for the control panel open.
2. Connect the power cord from the loop
generator/charger to the charger contact on the
mower. The green indictator lamp Battery now
goes on. When the mower is fully charged the
green indicator lamp goes off and the yellow lamp
starts flashing.
When the battery is flat it will take 4 - 5 hours before it
is fully charged.
To save floor space when storing or charging
Automower between mowing it can be hung up on a
®
wall by using the Automower
13-01).
30 - English
® needs charging it stops on the
® wall bracket (504 82
4. USE
2 m