Connecting The Boundary Wire - Husqvarna Automower 210 C Operator's Manual

Joining the boundary wire
If the boundary wire is not long enough and needs to
be spliced: Use original solderless coupler. It is
waterproof and gives a reliable electrical connection.
To splice: Insert both cable ends in the coupler. Now
press down the button on top of the connector fully.
Use a pair of pliers or the like, as the button on the
connector is difficult to press down by hand.
IMPORTANT INFORMATION
Twisted cables, or a screw terminal
(chock-block), insulated with insulation tape
is not a satisfactory splice. Soil moisture will
cause the conductors to oxidise and after a
while result in a broken circuit.

3.5 Connecting the boundary wire

Connect the boundary wire to the loop
generator/charger:
1. Place the cable ends in the connector:
• Open the connector.
• Place the wire in the connector grip.
2. Press the connector together using a pair of
pliers. Press until you hear a click.
24 - English
3. INSTALLATION