Linking Automower To The Loop Generator/Charger - Husqvarna Automower 210 C Operator's Manual

3.7 Linking Automower
generator/charger
1. Connect the loop generator/charger charging
cable to the mower's charger contact. At most
the mower may be two metres from the working
area's boundary wire and the loop
generator/charger must be connected to the
mains supply.
2. Open the control panel cover by pressing the
STOP button. Set the main switch to the ON
position.
3. The yellow indicator lamp PIN code should now
flash.
4. Select and enter a four digit PIN code. All
combinations except 0000 are permitted.
5. Press the YES button.
6. Confirm the selected PIN code by re-entering the
PIN code.
7. Press the YES button.
8. The yellow indicator lamp PIN code flashes
once, and then remains unlit.
When you have selected a PIN code, the mower and
loop generator/charger are linked to each other and the
mower can be operated.
26 - English
3. INSTALLATION
to the loop
®
2 m