State-Based Softkeys (Bottom Keys Only) - Aastra 57i IP Phone User Manual

Services
Callers List
Directory
Intercom
Empty
State-Based Softkeys
On the 57i bottom softkeys, you can configure a specific state to display
when a softkey is being used. Available states you can configure for each
softkey include:
• idle - The phone is not being used.
• connected - The current line is in an active call (or the call is on hold)
• incoming - The phone is ringing.
• outgoing - The user is dialing a number, or the far-end is ringing.
• busy - The current line is busy because the line is in use or the line is set
as "Do Not Disturb".
The following table identifies the applicable default states for each softkeys
type on the IP phone.
Softkey Type
None
Line
DND
Speeddial
BLF
BLF List
XML
lcr
Directory
Callers List
Intercom
26 Model 57i IP Phone User Guide
Indicates the softkey is set to be used as the
Services key.
Indicates the softkey is set for accessing the
Callers List.
Indicates the softkey is set for accessing the
Directory List.
Indicates the softkey is set to be used as the
Intercom key.
Indicates the softkey is configured to force a
blank entry on the IP phone display for a spe-
cific softkey. The soft keys are added in order
(from softkey1 to softkey20) after any hard-
coded keys have been added. If a particular
soft key is not defined, it is ignored.
(Bottom Keys only)
Default States
All states disabled.
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy