State-Based Softkeys (Bottom Keys Only) - Aastra 6757i CT User Manual

State-Based Softkeys
On the 6757i CT bottom softkeys, you can configure a specific state to display when a softkey is
being used.
The following table describes the states available to configure for the softkeys.
State
idle
connected
incoming
outgoing
busy
The following table identifies the applicable default states for each softkey type on the IP phone.
Softkey Type
None
Line
Speed Dial
DND
BLF
BLF List
Auto Call Distribution (ACD)
Directed Call Pickup (DCP)
Group Call Pickup (GCP)
XML
66
(Bottom Keys only)
None
None
None
(state-based)
Description
The phone is not being used.
The current line is in an active call (or the call is on hold).
The phone is ringing.
The user is dialing a number, or the far-end is ringing.
The current line is busy because the line is in use or the line is set as "Do Not Disturb".
Default States
All states disabled.
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
Softkeys
Model 6757i CT IP Phone User Guide
None
None
None