Adjustments - RIDGID R8652 Operator's Manual

OPERATION
WARNING:
Never extend your fingers while holding the lower
blade guard handle. Extending your fingers may
result in contact with the blade, causing serious
injury.
 Rest the front of the base flat against the workpiece with
the rear of the handle raised so the blade does not touch
the workpiece.
DANGER:
Always check to insure that your fingers are clear
of the blade before depressing the switch trigger.
Contact with the blade will cause serious injury.

ADJUSTMENTS

POSITIVE 0° BEVEL STOP
See Figure 21, page 16.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making
0° cuts. However, misalignment can occur during shipping.
To check positive 0° bevel stop:
 Remove the battery pack from the saw.
 Place the saw in an upside down position on a workbench.
 Move the lower blade guard out of the way so that the
saw blade is exposed.
 Check the squareness of the saw blade to the base of
the saw using a combination square.
 Depress the lock-off button and squeeze the switch trigger
to start the saw. Always let the blade reach full speed
then slowly lower blade into the workpiece until base is
flat against workpiece.
 Guide the saw into the workpiece and make the cut.
WARNING:
Always cut in a forward direction when pocket
cutting. Cutting in the reverse direction could
cause the saw to climb up on the workpiece and
back toward you.
 Release the trigger and allow the blade to come to a
complete stop.
 Lift the saw from the workpiece.
 Clear corners out with a hand saw or jig saw.
To adjust positive 0° bevel stop:
 Remove the battery pack from the saw.
 Rotate the bevel lock lever counterclockwise to release.
 Insert a 2.5 mm hex key (not provided) through the screw
hole in the saw base.
 Turn adjustment screw with 2.5 mm hex key (not provided)
and adjust base until it is square with the saw blade.
 Securely lock the bevel lock lever.
WARNING:
Attempting a bevel cut without having the bevel
lock lever securely locked in place can result in
serious injury.
11 - English