Assembling Leg Stand - RIDGID TS2424 Owner's Manual

Assembly (continued)

Assembling Leg Stand

1. Locate the carton containing the leg stand.
Remove all parts from packing material.
2. From the bag labeled "Legs" remove the following
hardware:
20 Truss Head Screws, 1/4-20 x 1/2" long
20 Lockwashers, 1/4" External Type
20 Hex Nuts, 1/4-20
From leg stand carton find the following:
4 Legs
2 End Stringers
2 Side Stringers
2 Leg Braces
3. From among the loose parts find the following:
2 Miter Gauge Storage Hooks
2 Rip Fence Storage Hooks
4. See special instruction sheet for installing storage
hooks.
5. Assemble the legs as shown.
Insert the truss head screws through the holes in the
legs, then through the holes in the side and end string-
ers.
Legs must be assembled on top of stringers
6. Install the lockwashers. Screw on the nuts hand tight.
7. Insert the truss head screws through the holes in the
legs, then through the holes in the leg braces.
8. Install the lockwashers. Screw on the nuts but do not
tighten until completely assembled.
1/4-20 x 1/2 In.
Truss Head Screw
End
Stringers
Leg Brace
Leg
Side Stringers
1/4-20
Hex Nut
Swivel Caster
Assembly Will Be
Installed Here
Lockwasher
Leg Brace
14
1/4-20
1/4 In. External
Hex Nut
Lockwasher
Side
Stringer
Miter Gauge
Storage Hooks
Rip Fence
Storage Hooks
End Stringers
Truss Head
Legs
Screw