Operational Difficulties - Ricoh Mv106 Operator's Manual

TROUBLESHOOTING

Operational Difficulties

Problem
STANDBY MODE
Nothing happens when the switch is
turned on.
SET DOC. OR DIAL NO. is not
displayed.
The display does not show the
Ready condition, or the machine
stops during operation.
TRANSMISSION
The original is not pulled into the
auto document feeder.
The machine cannot dial out.
58
Required Action
Check the power cord. Is it properly plugged into
the outlet?
Plug it in firmly
Switch the power on.
Check that the power cord is plugged in.
The machine might be in saving energy mode.
Hold down any key for two seconds.
Does CLEAR ORIGINAL or CLEAR COPY
appear in the display ?
Clear the misfeed. See page 56.
Does ADD PAPER appear in the display?
Load paper into the paper tray. See page 48.
Does CLOSE COVER appear in the display?
Close all covers.
You did not feed the document far enough into
the feeder.
Insert the document into the feeder until it
stops. Retransmit.
Clean the ADF rollers (see page 53).
If the same problem still exists after user
maintenance, contact your service
representative.
The telephone line is disconnected.
Check that the line is connected properly.
The telephone line type setting is incorrect.
Check the telephone line type setting
See page 84.
Operational Difficulties