Installing Sansurfer Iscsi Hba Manager; Initial Installation - Qlogic SANsurfer iSCSI HBA Manager User Manual

Management tool for qlogic iscsi host bus adapters

Table of Contents

Installing SANsurfer iSCSI

HBA Manager

Installing SANsurfer iSCSI HBA Manager consists of installing the SANsurfer

iSCSI HBA Manager user interface, a platform-specific agent, and help

components, as appropriate.

NOTE:

Before installing SANsurfer iSCSI HBA Manager, read and follow the

instructions in the documents listed in

applicable.

This section provides the following information:

"Initial Installation" on page 4-1

"Web- and CD-based Installation Updates" on page 4-17

"Uninstalling SANsurfer" on page 4-24

You can install the SANsurfer tool (which includes SANsurfer iSCSI HBA

Manager) using the files from the QLogic Web site or from the SANsurfer

CD-ROM.

The following information applies:

Install the same version of SANsurfer on all systems in the network.

Before installing SANsurfer, uninstall any previous versions of the SANsurfer

tool (for example, QMS 1.0 or QMS 2.0 (QMSJ)).

Installing and running SANsurfer Control iX and the SANsurfer iSCSI HBA

Manager user interface (interface only, not the agent) on the same system is

supported. When using only the SANsurfer iSCSI HBA Manager user

interface, this system monitors QLA4xxx HBAs on remote systems on the

same network.

IS0054602-00 B

"Related Documents" on page

1-3, as

4-1

Table of Contents

Troubleshooting

Do you have a question about the SANsurfer iSCSI HBA Manager and is the answer not in the manual?