Refreshing The Configuration Immediately; Iscsi Configuration Change Confirmation - Qlogic SANsurfer iSCSI HBA Manager User Manual

A
Figure 5-13 iSCSI Configuration Change Confirmation
3. To save your options changes, click OK. To close the Application Options
dialog box without making any changes, click Cancel.

Refreshing the Configuration Immediately

The configuration shown in the SANsurfer iSCSI HBA Manager user interface
refreshes based on the polling intervals (see
Retrieve Host Status Alarms" on page
to update when host status alarms occur
Configuration Refreshes When Host and Target Status Alarms Occur" on
page 5-19).
To refresh the configuration immediately:
Do one of the following:
On the toolbar, click Refresh.
On the SANsurfer iSCSI HBA Manager main window View menu, click
Refresh.
Press F5.
NOTE:
Selecting Refresh forces the agent to poll the HBA immediately and update
the SANsurfer iSCSI HBA Manager configuration with the latest HBA
information.
IS0054602-00 B
When the host configuration changes, the following confirmation
message (Figure
b. To refresh the configuration, click Yes. To continue to show the
current configuration, click No.
To prevent the iSCSI configuration change message from appearing
when a host configuration has changed, clear the Enable Prompt to
Accept Host Refresh check box. When host status alarms occur, the
configuration refreshes if it is set to update (see
the Configuration Refreshes When Host and Target Status Alarms
Occur" on page 5-19).
Setting Up SANsurfer iSCSI HBA Manager
5-13) appears.
"Specifying the Polling Intervals to
5-16) and whether the configuration is set
(see"Specifying Whether the
5 – Getting Started
"Specifying Whether
5-21