Step 4: Install And Run Sansurfer Iscsi Hba Manager; Remote Procedure Calls (Rpcs) - Qlogic SANsurfer iSCSI HBA Manager User Manual

A
Verification:
operating system device configuration utilities, or use SANsurfer iSCSI HBA
Manager to display target devices found on an HBA.
Windows: On supported Windows systems, use the computer management
utility to view which target devices are configured on which HBAs, and to
view and format devices and LUNs that are found.
Linux: On supported Linux systems, open /var/log/messages to view
which target devices are configured on which HBAs. Entries are also created
for each HBA recognized by the driver. Each entry contains information
about target devices and LUNs that are found.
Solaris: On supported Solaris systems, open /var/adm/messages to
view which target devices are configured on which HBAs.

Step 4: Install and Run SANsurfer iSCSI HBA Manager

For complete installation instructions, see section
HBA Manager.
SANsurfer iSCSI HBA Manager runs as both a tool with standalone (non-agent
mode) access to local system QLogic iSCSI HBAs and as a client/server tool. The
client tool runs on a hardware platform that supports Java™ and agents running
on each system that has QLogic HBAs.
If you are using SANsurfer iSCSI HBA Manager on a host system where HBAs
are installed, install the SANsurfer iSCSI HBA Manager tool (the user interface) on
the local host. Installing the SANsurfer iSCSI HBA Manager agent on the local
host is optional.
When it is installed on the local system, the agent is used instead of the non-agent
mode.

Remote Procedure Calls (RPCs)

SANsurfer iSCSI HBA Manager, uses remote procedure calls (RPCs) as follows:
In Windows, the RPC service (ONC/RPC Portmapper) required by
SANsurfer iSCSI HBA Manager is installed automatically.
In Linux, the appropriate RPC libraries must be installed by the Linux
distribution. For information about installing RPC services before installing
SANsurfer iSCSI HBA Manager, see the Linux distribution documentation.
In Solaris SPARC, the /usr/sbin/rpcbind process is required for RPC
communication of the remote agent.
IS0054602-00 B
3 – System Requirements and Installation Checklist
Verify that the HBAs recognize target devices by using the
Installation Checklist
4 Installing SANsurfer iSCSI
3-3