Logged-In Led Indications - Qlogic 5800V Series Installation Manual

Logged-In LED Indications

Port diagnostics are indicated by the Logged-In LED for SFP and XPAK ports as
shown in
The Logged-In LED has three indications:

Continuous illumination: A device is logged in to the port.

Flashing once per second: A device is logging in to the port, or the port is in
the diagnostics state.

Flashing twice per second: The port is down, offline, or an error has
occurred.
If a Logged-In LED is flashing twice per second, review the event browser for
alarm messages regarding the affected port. You can also inspect the alarm log
using the Show Alarm command. If there is an error, alarm messages may point to
one or more of the following conditions:

E_Port Isolation

Excessive Port Errors
59265-02 B
Figure 4-6.
SFP Port
Logged-In LED
Figure 4-6. Logged-In LED
4–Diagnostics/Troubleshooting
Power-On Self Test Diagnostics
XPAK Port
Logged-In LED
4-7