Exiting The Maintenance Menu (Option 0); Unpacking A Firmware Image File In Maintenance Mode (Option 1) - Qlogic 5800V Series Installation Manual

4–Diagnostics/Troubleshooting
Recovering a Switch Using Maintenance Mode
4. The Maintenance menu lists several recovery options. To select a switch
recovery option, type the corresponding number, and then press ENTER.
These options and their use are described in the following subsections.

Exiting the Maintenance Menu (Option 0)

The Exit option closes the current Maintenance menu session. To log in again,
type the maintenance mode account name (prom) and password (prom). To return
to normal operation, momentarily press and release the Maintenance button, or
power cycle the switch.
Unpacking a Firmware Image File in Maintenance Mode
(Option 1)
The Image Unpack option unpacks and installs new firmware when the current
firmware has become corrupt. Before using this option, you must load the new
firmware image file onto the switch. To install new firmware using this option:
1. Place the switch in maintenance mode. Refer to the procedure for
maintenance mode in
page
2. Use FTP to load a new firmware image file onto the switch. Refer to
Firmware Installation" on page 3-17
file. When the download is complete, close the FTP session.
3. Establish a Telnet session with the switch using the default IP address
10.0.0.1. For example:
4. Type the maintenance mode account name (prom) and password (prom).
4-14
0) Exit
1) Image Unpack
2) Reset Network Config
3) Reset User Accounts to Default
4) Copy Log Files
5) Remove Switch Config
6) Remake Filesystem
7) Reset Switch
8) Update Boot Loader
Option:
"Recovering a Switch Using Maintenance Mode" on
4-13.
telnet 10.0.0.1
Switch login: prom
Password:xxxx
for an example of how to load the image
"Custom
59265-02 B