Table of Contents
Advertisement
Computer Control Commands
Introduction
The following commands are for use by software developers that have highly-
developed technical knowledge. Operators should not try to control the Tester
using these commands; rather, they should use Ansur test automation software.
The Tester acknowledges each valid computer control command that it
receives. It responds to valid commands either with ACK (HEX 06), or ACK,
followed by the data, followed by CR-LF (HEX 0D0A). A NAK (HEX 15) is
returned for invalid commands.
The computer control commands are shown in Table D-1.
Description
Internal Adult Cuff
Neonate Cuff
External Cuff
Wrist Cuff Simulation
Table D-1. Computer Control Commands
[CUFF_IA]
[CUFF_IN]
[CUFF_EXT]
[SIM_WC120_80]
[SIM_WC160_100]
[SIM_WC80_55]
Command
Appendix D
Returned
String
ACK
ACK
ACK
ACK
ACK
ACK
D-1
Hide quick links:
Advertisement
Table of Contents
