EverFocus NVR User Manual page 11

Step 4: Connect the Power
1. Attach the power cord from the power source to the power adapter.
2. Connect the power adapter to the back of the unit enclosure. See the rear
view diagram.
3. On the front of the unit, press the power button. See the front view
diagram.
It takes about a minute for the unit to fully power up. Once it is powered up:
 The System Status LED turns blue. See the front view diagram.
 The buzzer beeps one time.
Step 5: Install the Software on your Computer
1. Insert the CD into your computer's CDROM drive.
2. Double-click the Setup.exe command to begin installation.
3. Follow the instruction of the Setup.exe program, and click the Finish
button to close the installer.
Step 6: Set up the Unit
The software Installation Wizard performs the setup procedures on the unit.
After this procedure, you can begin using it.
1. Go to Start > NVR > NVR Install Wizard.
2. This program will show the default language setting and initiation mode.
3. Choose your preferred language and initiation mode, and then click the
button.
10