Levels And - Sony STR-DG500 Operating Instructions Manual

8: Adjusting the speaker
levelsand balance
(TEST TONE)
You can adjust the speaker levels and balance
while listening to the test tone from your
listening position.
Tip
Tile receiver employs a test tone with a frequency
centered at 800 Hz.
2-I
MASTER
VOL +/-
Press control button ,i,14,
repeatedly to select "T. TONE
y",
Tile test tone is output from each speaker
in sequence as follows:
Front left _ Center _ Front right
Surround right _ Surround back
Surround left _ Sub woofer
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see "Adjusting the level
(LEVEL menu)" (page 38).
Tips
•To adjust the level of all speakers at the same
time, press MASTER VOL +_. You can also
use MASTER VOLUME on the receiver.
•The a{liusted value are shown on the display
during ac[justment.
Repeat steps 1 to 5 to select
"T. TONE N".
The test tone turns oft'.
Note
The test tone does not work when MULTI CH IN or
ANALOG DIRECT is selected.
4
! Press AMP MENU.
"I-LEVEL" appears on the display.
2
Press the control button or
control button * to enter the
menu.
3
Press control button €/_
repeatedly to select "T, TONE".
4
Press the control button or
control button * to enter the
parameter,
30G8