Sony STR-DG500 Operating Instructions Manual page 28

The table below shows the display when
measnrenlent starts.
Measurement for Display
Enviromnent noise level NOISE.CHK
Speaker connection MEASURE and SP
DET. appears
alternately :
Speaker level MEASURE and
GAIN appears
alternately :
Speaker distance MEASURE and
DISTANCE appears
alternately :
: The corresponding speaker indicator lights up ill
the display during measurement.
When measurement ends, "COMPLETE"
appears on the display and the settings are
registered.
Notes
• Auto Calibration canuot detect tile sub v_ool'cr.
Therefore. all sub woofer settings will be
maintained.
• You cannot select Auto Calibration when
headphone is connected.
• The measurement process will take a few minutes
to complete.
Tips
• When Auto Calibration starts:
Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
Avoid making noise to get a more accurate
measurement.
• The Auto Calibration l'unction will be canceled
when you do tile following during the
measurement process:
Press I/(_), iupul buttons or MUTING.
Change the vohlme level.
Press AUTO CAL again.
Error codes
When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follows:
Error code _ blank display _ (error code
blank display) a) _ PUSH _ blank display
-_ ENTER
a)Appears when there are more Ihau oue error code.
To rectify the error
1 Record
down the error code.
2 Press the control button.
3 Press I/(.D to turn off the receiver.
4 Rectify the error.
For details, see "Error code and remedies"
below.
5 Turn on the receiver
and perform Auto
Calibration again (page 27).
Error code and remedies
Error Explanation Remedies
code
ERROR 10 The environment Make sure tile
is too noisy, environment is
quiet during Auto
Calibration.
ERROR 11
The speakers are Place yourspeakers
placed to/1near further a'_ay ff//m
tileoptimizer tile optimizer
microphone, microphone.
ERROR 20
Front speakers Check tile flout
are not detected speaker
or only one front counectiou.
speaker is
detected.
ERROR 21 Only one Check the surround
surround speaker speaker
is detected, connection.
ERROR 23 Surrouud back Be
sure to couuect
speaker is tile surround
detected but speakers.
surround
speakers are not
counected.
28 G8