FARGO electronics Persona C30 User Manual page 71

RESTRICTED USE ONLY
Resolving a Ribbon Sensor Error (Ribbon Miscue) (continued)
Step Procedure
2 Open the front cover and remove the Ribbon Cartridge.
a. Check that the Ribbon is in good condition and not wrinkled or broken.
b. If Ribbon is broke or wrinkled, repair the Ribbon and wind up the take-up
roll 4-color panels past the damaged area.
3 Press on the Resume button.
If the issue persists, continue to Step 4.
4 Replace the Ribbon Cartridge.
a. Press on the Resume button.
b. If the issue persists, continue to Step 5.
5 Press the Cancel Print button on the Driver Monitor Error Display Message.
6 Reboot the Printer by cycling the power.
7 Use the Driver Calibration tab to calibrate the Ribbon Sensor. Cover the front
of the printer to block the light while calibrating this sensor.

If the issue persists, continue to Step 8.
8 Replace the Ribbon Sensor.
Persona C30 Card Printer User Guide (Rev. 2.2)
Fargo Electronics, Inc.
4-18