Table of Contents
Advertisement
Setting Up
Power ON / OFF
AC inlet
1.
Active Area
2.
3.~4.
Outlet
Focus ring
5.
Turning On The Power
1. Make sure that power cord is firmly and
correctly connected to the projector.
2. The green Power indicator blinks slowly.
3. Remove the lens cover.
4. Press POWER button on the Touch Keypad
or the remote control to turn on the projector.
5. Rotate the focus ring to adjust the focus.
WARNING
A strong light is emitted when the projector's
power is on. Do not look into the lens of the
projector or look inside of the projector through
any of the projector's openings.
Turning Off The Power
1. Press the POWER button on the Touch
Keypad or the remote control. The "power
off" confirmation message will appear.
2. Press the POWER button again while the
message is shown on the screen.
3. When the projector enters "Standby" mode,
the green Power indicator blinks slowly.
4. The projector cannot be turned on while red
"Lamp indicator" is blinking slowly in cooling
mode.
5. If you don't use the projector for a long time,
remove power cord.
WARNING
Do not touch around the lamp cover and the
exhaust vents during use or just after use, since it
is too hot.
CAUTION
Do not turn off the AC power for 120 seconds
after the lamp is turned on. Doing so could cause
premature lamp failure.
13
Advertisement
Table of Contents
