Security Menu - Eiki LC-WIP3000 Owner's Manual

MENU

Security Menu

Item
PIN LOCK
PROTECTION
MODIFY PIN
Selection
OFF: Turn off PIN lock protection.
ON 1: After plugging in AC power, you need to key in PIN
OFF
ON 2: You need to key in PIN code every time when you
ON 1
ON 2
Once the PIN code had been set, the projector cannot be
used unless you enter the correct PIN code.
1. Press " MENU " on the projector or remote control.
2. Use the ► button to select the MODIFY PIN item in the
SECURITY category.
3. Press the ► button to change PIN LOCK PROTECTION
mode.
4. Please enter the original PIN code.
(a) If the PIN is correct, system will allow you to change
(b) If the PIN is incorrect, a " Code Error " message will appear.
EXECUTE
5. Please enter a new PIN code. And then enter again to confirm.
NOTE:
(1) To change the PIN lock protection state, you must
(2) Please enter: 0000 for first-time use.
(3) To avoid unnecessary trouble, if you activate the [PIN
Description
code at the first time of use. If the AC power stays
unplugged, you do not need to key in PIN code next
time when you use the projector.
turn on the projector.
CAUTION:
a new PIN code.
enter the PIN code first.
Lock Protection], it is highly recommended that you
write down the PIN code and store it in a safe place.
33
Step:
1. Use the ▲ /▼buttons to
select an item.
2. Use the ◄ / ► buttons to
select an item or adjust the
value.