Table of Contents
Advertisement
Troubleshooting
Indicator
The power and lamp indicators show the status of the projector. Before requesting repair,
check the projector status using the chart below. If the problem cannot be resolved,
contact your dealer.
In normal status~~~
POWER
Blinking In
Green
Lighting In
Green
Lighting In
Green
Lighting In
Green
In abnormal status~~~
POWER
Blinking In
Green
Blinking In
Green
Blinking
In
Green
(Fast)
Blinking In
Green
(Slow)
LAMP
Off
Stand by mode
Off
On mode
Blinking In
Red
Cool down mode
( Slow )
Blinking In
Red
Cool down mode
( Fast )
LAMP
Blinking In
Red
Fan fault mode
( Fast )
Lighting In
Red
Lamp cover open
Blinking In
Red
High temperature
( Fast )
Blinking In
Red
Lamp fail
(Slow)
CONDITIONS
CONDITIONS
64
DESCRIPTION
Projector is ready to be turned
on.
Projector is on and operating.
Projector is in cool down mode
and will not respond to user
input.
When the projector is turned on
in 2 minutes after it was turned
off.
DESCRIPTION
The projector has detected a
problem of a slow internal fan
speed. The lamp will shut off
automatically. Contact your dealer.
The lamp cover is open or not
closed well. Please check lamp
cover again.
The projector has overheated and
shut itself down.
Correct the over temperature
condition immediately.
1. Check that the ventilation slots
are free from obstructions.
2. Check the cleanliness of the air
filter.
The lamp does not light. Come
to "stand by mode", and press the
power button again. If the situation
is the same, please contact your
dealer.
Advertisement
Table of Contents
