Brocade Communications Systems Brocade 300 Administrator's Manual page 21

3. Connect the power cord to the switch and plug in to a power source.
4. Connect an Ethernet cable from the Brocade switch to the LAN you want to use for your
5. If you are using a serial connection for setup, connect your setup computer to the serial port on
6. Click Next.
EZSwitchSetup Administrator's Guide
53-1002744-01
1 Brocade switch
2 Power cable
3 Ethernet hub or switch
4 Serial cable
FIGURE 6
Cable connections
The switch power and status LEDs display amber and then change to green, which usually
takes from one to three minutes. See your switch hardware manual for the location of the
LEDs.
management connection through an Ethernet hub or switch. If you chose to use your Ethernet
connection for setup in step 1, this is the connection you will use. If you chose the serial cable
connection in step 1, you should still connect the Ethernet cable so the Ethernet connection
will be available when you start the EZSwitchSetup Manager.
the switch, using the serial cable shipped with the switch. If you cannot locate the serial cable
that came with the switch, you will need to find one that has the appropriate connectors. Do
not use a null-modem cable. The serial connection settings are as follows:
•
Bits per second: 9600
•
Databits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
EZSwitchSetup attempts to discover the switch. If your switch discovery fails, see
page 17 for details on how to recover your switch.
If you are using the serial connection, the Set Switch IP Address window is displayed, and you
can go to step 5. You can now remove the serial cable from the switch, but keep it available in
case you lose your network connection and need to revise any of the information you entered.
Installing and running the EZSwitchSetup wizard
0 1 2 3 8 9 10 11
4 5 6 7 12 13 14 15
5 Setup computer
6 Ethernet cable from hub to Brocade switch
7 Ethernet cable from setup computer to Ethernet hub or switch
2
Table 2 on
11