Discovering The Switch - Brocade Communications Systems Brocade 300 Administrator's Manual

2
Installing and running the EZSwitchSetup wizard

Discovering the switch

1. Locate the WWN for your switch on the switch ID pull-out tab located on the bottom of the port
2. From the Switch WWN list
3. Click Next.
12
If you are using an Ethernet LAN connection, a Discover Switch window is displayed
Proceed to "Discovering the switch."
FIGURE 7
First Discover Switch window
side of the switch.
the last six alphanumeric digits of your switch's WWN. Each two alphanumeric digits must be
separated by a colon.
When EZSwitchSetup discovers the switch, it displays the discovered IP addresses (IPv4 and
IPv6), as shown in Figure
If you are setting up the switch for the first time, the IP addresses are placeholder addresses
that were assigned at the factory and you must provide valid addresses.
(Figure 7), choose the switch's WWN prefix numbers and then enter
8.
(Figure
EZSwitchSetup Administrator's Guide
53-1002744-01
7).