Hand Held Products 7900L00-414C50E - Dolphin 7900 User Manual page 106

2. In the Preferred Profile list, select the SSID and tap Edit
3. Follow the same process for creating a profile.
4. When configuration is complete, tap OK.
5. The SSID and its profile are added into the Preferred Profiles list.
If you're adding an SSID with the WEP Key turned off, the Settings window does not display and the SSID is added directly
to the Preferred Profile table.
To Create a New Profile
In the Preferred Profiles section, tap the New button
Network Profile Tab
Field
Network Name &Type
SSID
TX Rate
Type
Chan
AP Search
Threshold
OK
Cancel
Note: The SSID, Type, TX Rate, and Channel fields are unchangeable in AP mode, whereas TX Rate and Channel fields
can be changed in Peer-to-Peer mode.
9 - 6
Downloaded from www.Manualslib.com
Description
Enter an SSID, which is the Network Name. Check with your network administrator for Network Name
(SSID).
Choose the transmit rate from the drop-down list - 1MB, 2 MB, Auto 1/2 MB, 5.5 MB, 11 MB, or Fully Auto.
The transmit rate is set to Fully Auto by default.
From the drop-down list, select
Peer-to-Peer – This mode used for communication between two (or more) radio stations (cards) without
an AP.
Access Point (AP) – This mode is also called "Infrastructure" mode.
Scroll to select a channel for communication.
Select Low Density (default), Medium Density, or High Density from the drop-down list and tap OK.
AP search thresholds are used for wireless client roaming between APs. In general, the higher the density
selected here, the easier your WLAN card roams between APs with the same SSID in the same network.
Roaming also depends on the relative signal strength of the AP.
Tap this button to save the profile or changes to the profile.
Tap this button to close the window without saving or modifying the profile.
manuals search engine
.
. Complete the Network Profile and Authentication tab windows.
Rev D Dolphin® 7900 Series User's Guide