Recording (Deck I) - Pioneer CT-WM62R Operating Instructions Manual

INDICATORS
I FLEx iiif) SYSTEM _
• FLEX System: F_requency Leve_ Expander System
• During playback, the FLEX system automatically com-
pensates tapes with poor sound quality at high frequency
levels of 1 kHz to 20kHz, based on the appropriate auditory
characteristics.
The FLEX system performs playback with up to a 12dB
improvement in 10 kHz high frequency reproduction, parti-
cularly in tapes with poor clarity and sound presence at high
frequency levels.
• When you press the FLEX button to turn the FLEX system
on, the 1/f indicator light and start playback, the(€_J)indi-
cator flash end compensation adjustment begins.
After approximately 3~8 seconds, compensation adjustment
is completed and the indicators change from a flashing to a
steadily lit condition. Some music selections may take a
little longer than 8 seconds.
• When the FLEX system is engaged, each music selection is
automatically adjusted during playback. System operation
status is indicated by whether the (=_J} indicators are
flashing or steadily lit.
• Even when the FLEX system is turned on, during all
recording functions, including CD-DECK synchro recording
and tape copying, the 1/f indicator is nullified automatically.
• After beginning playback, all compensation data is me-
morized even if the playback is stopped. As a result, the
same compensation data will be used when the playback is
restarted. The memorized compensation data will be
canceled, however, if the FLEX button is pressed again, if
the tape is ejected, or if recording is begun.
NOTE:
When a tape has been recorded at a high frequency level
above the compensation level, the FLEX system operation is
automatically defeated during playback.
RECORDING(DECKI)
1 2,3 4
3 4 5
1
2
_- = c !
6 9 785
.aWEP
-=lj
/9
6
_L=Y NR
/9
I
©
e _ 4 s B
@ @ © © @
_lv_sE
MOD_
8
9
I-I
• I "- I
/9 (
Before turning on the POWER switch, make sure that the
DECK I TIMER switch is set to OFF. If the DECK I TIMER
switch is set to REC or PLAY, recording or playback will
automatically begin approximately 10 seconds after the
POWER switch is turned on.
1. Turn the POWER switch on.
2. Place the cassettes on the tray.
Press the OPEN/CLOSE button and the tray will automati-
cally slide open. Insert the cassettes with side A on the left,
and the exposed (tape) side facing down. The tray can hold
up to 6 cassettes at a time.
15
<RRB1134>
En