Pioneer CT-WM62R Operating Instructions Manual page 12

E"EMOTE CO.T.O. ON,T,OS and Canad,an mode,s on,y, • ]
®
®
PlONIEEIR l ml
B©
c=?,
®
®
®
®
®
• The remote control unit buttons operate in the same way as
the cassette deck buttons.
COUNTER MODE button
See page 14.
COUNTER RESET button
See page 14.
(_ RELAY button
See pages 17 and 19.
All rewind button (ALL REW)
If this button is pressed when the unit is in the stop mode,
all the cassette tapes in DECK I will be rewound (at high
speed) to the beginning of side A, beginning with the
cassette in the lowest numbered slot. If this button is
pressed during tape playback, or otherwise when a tape
has been loaded in the tape transport mechanism, the ALL
REWIND operation will begin from the currently playing
tape. "RL L" appears on the multifunction display when the
button is pressed.
(_ SCAN button
See page 19.
RANDOM button
See page 19.
DECK II operation buttons
See page 9.
(_ DECK I operation buttons
See page 10.
• Both recording (o) buttons must be pressed at the same
time to begin recording.
(_ CASSETTE NUMBER buttons (1~6)
See page 10.
(_ RETURN button
Press this button to return the tape currently loaded in
DECK I to the tray.
12
<RRB1134>
En
Remote control
senser window
7m
(23 ft)
(_ OPEN/CLOSE button
See page 10.
NOTES:
• Remote control will not be possible if there is an obstacle
between the remote control unit itself and the remote
control sensor window of the cassette deck
• If there is no response even when the remote control is
used directly in front of the cassette deck, the batteries may
need to be replaced
• Performance of the remote control unit is adversely af-
fected by strong fluorescent light. Keep such lights away
from the sensor window in particular.
OPERATION OF DECK I WITH A REMOTE
CONTROL UNIT NOT DESIGNED FOR DOUBLE
DECKS (System remote control)
Selecting DECK I
In order to operate DECK I with the remote control unit, adjust
the cassette deck as follows: With the power off, press and
hold the stop (11) button of DECK I, and turn the power on.
Continue to hold the stop (11) button until the cassette
indicators on the door stop flashing. DECK I can now be
operated using the remote control unit, but DECK II cannot.
Switching to DECK II
To restore remote control operation to DECK II, press the stop
(11)button of DECK II while DECK II is in stop mode. DECK II
can now be operated using the remote control unit. Remote
control operation can be switched back and forth between
DECK I and DECK II by pressing the stop (i) button of the
desired deck while it is in stop mode.
NOTE:
If the power supply is turned off, or if a power failure or a
sudden change in the power supply (caused by lightning, etc.)
occurs, the cassette deck is reset to its original state. Only
DECK II can be operated by remote control. To restore opera-
tion to either deck, repeat the procedure above from the
beginning.