Front.panel.configuration.port; Host-To-Switcher Instructions; Switcher-Initiated Messages - Extron electronics MVX VGA A User Manual

Computer video (vga) and audio matrix switchers
Table of Contents

Advertisement

Front panel Configuration port
N This port is hardwired for RS-232 only.
The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable, part #70-335-01
(figure 4-2) can be used for connection to the Configuration port.
1
6
9
5
9-pin D
Pin 2
Pin 3
Pin 5
Figure 4-2 — Optional 9-pin TRS RS-232 cable
N This port is independent of the rear panel Remote port and is not affected by

Host-to-Switcher Instructions

The switcher accepts SIS (Simple Instruction Set) commands through either serial
port. SIS commands consist of one or more characters per command field. They do
not require any special characters to begin or end the command character sequence.
Each switcher response to an SIS command ends with a carriage return and a line
feed (CR/LF =
is one or more characters.

Switcher-Initiated Messages

When a local event such as a front panel operation occurs, the switcher responds
by sending a message to the host. The switcher-initiated messages are listed below
(underlined).
(C) Copyright 2006, Extron Electronics CP 300 450 MAV IP, Vx.xx, 60-nnn-01
The switcher initiates the copyright message when it is first powered on. Vx.xx is
the firmware version number; nnn is the part number for your switcher model.
Qik
]
The switcher initiates the Qik message when a front panel switching operation has
occurred.
Sprnn
]
The switcher initiates the Spr message when a memory preset has been saved from
the front panel. nn is the preset number.
Rprnn
]
The switcher initiates the Rpr message when a memory preset has been recalled
from the front panel. nn is the preset number.
Part #70-335-01
Connection
TRS Plug
Computer's RX line
Computer's TX line
Computer's signal ground
changes to the rear panel port's protocol. This front panel port's protocol can be
changed via SIS command control only. See the Command/Response table for
SIS commands, later in this chapter, to configure both ports under SIS control.
]
), which signals the end of the response character string. A string
MVX VGA A Matrix Switchers • Programmer's Guide
6 feet
(1.8 m)
Sleeve (Gnd)
Tip
Ring
Sleeve
Tip
Ring
]
4-3

Advertisement

Table of Contents
loading

Table of Contents