Features - Extron electronics CrossPoint 450 Plus Series User Manual

Introduction, cont'd

Features

Video — All switchers input and output video on BNC connectors.
CrossPoint 450 Plus — These switchers input and output ultra-wideband
MAV Plus — These switchers input and output NTSC 3.58, NTSC 4.43, PAL, or
Bandwidth —
CrossPoint 450 Plus — The CrossPoint 450 Plus Series switchers provide a
MAV Plus — The MAV Plus switchers provide a minimum of 150 MHz (-3 dB)
Audio inputs (audio models only) —
All audio models, with the exception of the MAV Plus 128 AV RCA — Input
MAV Plus 128 AV RCA — Input and output unbalanced stereo audio on left and
Audio input gain/attenuation (audio models only) — Individual input audio
Audio output volume (audio models) — The audio volume of each output can be
1-8 CrossPoint 450 Plus and MAV Plus Matrix Switchers • Introduction
RGBHV or RGBS video. They can also switch RGsB, RsGsBs, component/
HDTV, S-video, or composite video.
SECAM video or HDTV video inputs. Depending on the video format of the
switcher, these switchers can distribute low resolution RGsB, RsGsGs,
component/HDTV, S-video, or composite video.
minimum of 425 MHz (-3 dB) video bandwidth, fully loaded.
video bandwidth, fully loaded.
and output stereo audio, balanced or unbalanced, on 3.5 mm, 5-pole captive
screw terminals.
right RCA connectors.
levels can be adjusted so there are no noticeable volume differences between
sources. Users can set the input level of audio gain or attenuation
(-18 dB to +24 dB) via the Ethernet link, either serial port link, or the front
panel.
displayed and adjusted through a range of full output to completely silent
from the front panel or under serial port or Ethernet control.