Extron electronics CrossPoint 450 Plus Series User Manual page 70

Press and hold the RGBHV button for approximately 2 seconds (figure 3-38).
2.
Press and hold the RGBHV
button until it blinks.
Figure 3-38 — Select RGB Delay mode
3. Press and release the output 17 button (figure 3-39).
1
Press and release the
17 18 11 32
Output 17 button.
The button lights green.
Figure 3-39 — Select an output
4. Press and release the Esc (
delay by a half second.
Press and release the Esc (
a whole second. Note the input button indication changes that occur each
time the Esc ( ) button is pressed and released.
Figure 3-40 show the result of pressing the Esc ( ) button a total of 3 times.
Press the Esc button to increase
the RGB interval that is applied to
switches to the selected output by
a half second per button push.
ESC ESC
Figure 3-40 — Adjust the RGB delay interval
RGBHV RGBHV
2 seconds
The input buttons 1 through 10 display the selected
output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 3.5
seconds of RGB delay.
0.5 1.0
O
2 5 16 1
U
T
P
U
17 18 19 20 21 22 23 24 31 32
T
S
= Unlit button
The RGB delay is protected when front panel lock mode 2 is selected. You can
view the delay in lock mode 2, but not change it from the front panel.
If front panel lock mode 2 is selected and you try to perform steps 4, the
actions are ignored and the Enter, RGBHV/Video, and Audio buttons flash.
) button once (figure 3-40) to increase the RGB
) button twice more to increase the RGB delay by
Input buttons 1 through 10 display the selected output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 5.0 seconds of RGB interval.
0.5 1.0 1.5
1 1 2
ESC
17 18 19 20 21 22 23 24 25 26
= Unlit button
CrossPoint 450 Plus and MAV Plus Switchers • Operation
1.5 2.0 2.5 3.0 3.5
2 3 4 5 6 7
= Lit green button
2.0 2.5 3.0 3.5 4.0
3 4 5 6 7 8
= Lit green button
I
8 15 16
N
P
U
T
S
4.5 5.0
I
9 10 16
N
P
U
T
32
S
3-27