Removing The Blackdiamond 8806 Ac Power Cord Retainer Channel - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

BlackDiamond AC Power Cord Retaining Brackets
Figure 85: Routing the Power Cords in the Channel
From the left, lay first four
power cords into channel bracket
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
Removing the BlackDiamond 8806 AC Power Cord Retainer
Channel
To remove the BlackDiamond 8806 AC power cord retainer channel:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top-left corner of the switch front panel.
2 Using a #2 Phillips screwdriver, loosen the captive screw located on each end of the AC power cord
retainer channel.
3 Remove the retainer channel from the switch.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
130
Lay last two power cords
onto others
BlackDiamond 8800 Series Switches Hardware Installation Guide